How to connect a tape player to your computer?

on Tuesday, July 15, 2008


If you recorded audio onto an audio tape, you can connect the tape player directly to your computer and record from it just as if you were recording from a microphone. Buy a patch cable (available at almost any electronics store) with two male mini-jacks (standard small audio connectors used by most current headphones, microphones, and computer speakers). Connect one end of the patch cable to the headphone jack on the tape player and connect the other end to your computer’s microphone jack. The key, of course, is to have the right kind of cable. You can even buy cables that allow you to connect an old record player to your computer and record audio from your old LPs.
Once connected, you can record audio from the tape using the same steps described in the sections in this chapter on microphone recording. You’ll have to coordinate your fingers so that you press Play on the tape player and click Record in the recording software at about the same time. If the recording levels are too high or too low, adjust the volume control on the tape player.